Fronius Symo Advanced 10.0-3-M - Page 78

An overview of the values that can be
changed is displayed.
3
Use the "Up" and "Down" keys Select
"Set time"
4
Press the "Enter" key
The current time appears. (HH:MM:SS, 24-
hour clock), the "tens" digit for the hour will
flash.
5
Use the "Up" and "Down" keys to se-
lect a value for the first digit of the code
6
Press the "Enter" key
The "units" digit for the hour will flash.
7
Repeat steps 5 and 6 to set the "units"
digit for the hour, for the minutes and for
the seconds until...
the set time starts flashing.
8
Press the "Enter" key
The time is applied and the overview of val-
ues that can be changed is displayed.
4
Press the "Esc" key
The "Clock" item on the Setup menu ap-
pears.
78