104
1. Loosen hexagon bolt (5) on minus
socket using size 19 spanner
2. Unplug 8-pin Molex plug (6)
3. Loosen two screws (7) on shunt (8)
4. Remove shunt (8) and feed out
throttle lead (9)
Removing shunt
(continued)
Fig.4 Removing shunt
(5)
(6)
(7)
(7)(8)(9)
Fitting shunt
Fig.5 Fitting shunt
(5)
(6)
(7)
(7)(8)(9)
1. Feed throttle lead (9) through shunt
2. Fit shunt (8) using two screws (7)
3. Plug in 8-pin Molex plug (6)
4. Push following components onto hexagon bolt (5):
Lock washer (10)
spacer (11)
throttle lead cable lug (12)
star (13) with protective element
5. Tighten hexagon bolt (5)
Fig.6 Components on the minus socket
(5)
(10)
(11) (12)
(13)
(2)
Fig. 7 Connecting drive unit
1. Reconnect two-pin Molex plug (4) for drive unit
(4)
To Next Page
Loading...
