Fronius TransSynergic 5000 - Special Displays Used with Service Codes

34
- And | Opc
- Prt | Flt
- Ill | Opa
- Ill | Ina
- Ill | Bus
- Err | 105
If the service codes shown above appear, more detailed information can be requested
at the power source control panel. Using the parameter selection buttons (left/right
arrows), you can switch between the following display levels:
- Level 1 (e.g. „And | Opc“): service codes display
(appears automatically)
- Level 2 (e.g. „CS 01“): segment display
(press parameter selection button once)
- Level 3 (e.g. „IP 3456“): instruction pointer
(press parameter selection button again)
Important! Please make a note of the displays in levels 1, 2, and 3, and pass them on
to Fronius. Using this data, Fronius can locate the precise cause of the fault.
- STK | OVL
- STK | UVL
- Err | Dog
- ASS | Ert
- Edg | 1
Special displays
used with service
codes
The following service codes are special displays for software problems: