Fronius TransSynergic 5000 - Poor Ignition and Welding Properties with MIG;MAG Welding

15
EN
Poor ignition and
welding proper-
ties with „MIG/
MAG welding“
End
Correct shielding gas connected,
and l/min set correctly?
Start
Gas-test button: Shielding gas
flowing out?
Welding torch and grounding
(earthing) cable OK?
Parameters set correctly?
Check shielding gas solenoid
valve, including control
Check welding torch and groun-
ding (earthing) cable
- Check settings on control panel
- Check set-up parameters
- Possibly reset to factory set-
tings (FAC) (see operating instruc-
tions)
Check whether power source OK,
and check application
Connect correct shielding gas and
check l/min
Yes
No
No
No
Yes
Yes
Yes
No