Fronius TransSynergic 5000 - TIG Welding Procedure

114
1. Fit capacitors (7), including grommets (8), in place (Fig.5)
2. Hold capacitors in place and fit using capacitor nuts (6) (Fig.7)
Fitting intermedi-
ate circuit capa-
citors
Important! After removing a capacitor (7), its grommets (8) - Fig.5 - can either
- adhere to the front of the capacitor (7)
- remain on the partition (9) inside the power source
- be disposed of
NOTE! When fitting the capaci-
tors, ensure that the grommets
(8) are arranged correctly, as
shown in Fig.5.
Fig.6 Putting capacitors in place Fig. 7 Fitting capacitors
(7)
(6)
Fit the following elements using capacitor screws (5):
1. Capacitor leads „ELKO1+“ to „ELKO2-“
2. Connecting lead (10)
Fig. 8 Connecting leads
(5)
(5)
(7)
Fig.5 Fitting capacitors
Fig 9 Installing capacitor
+
-
+
-
(5)
„ELKO1-“
„ELKO2+“
„ELKO1+“
„ELKO2-“
(10)
(7) (8) (6)
(5)
(5)
(5)
(9)