Fronius TransSynergic 5000 - Page 96

94
1. Feed the throttle lead (2) into the shunt (3)
2. Push the following components onto the hexagon bolt (size 13) in the order they
are given below:
- Spring washer (14)
- Spacer (15)
- Throttle lead cable lug (16)
- Star with protective element (17)
3. Tighten hexagon bolt (1) onto minus socket using a size 13 spanner
4. Fitting the side panels
Fitting throttle
(continued)
Fig. 10 Fitting front of the housing
NOTE! When fitting the control
panel (7), take care not to bend,
stretch or strain the ribbon cable.
1. Plug ribbon cable into control panel (7)
2. Carefully put control panel (7) in
place
3. Tighten screw (6) on front of the
housing
1. Place front of housing onto base
plate and press upwards and inwards
2. Tighten 2 screws (8)
Fig.9 Putting front of housing in place
Fig. 11 Fitting throttle lead
Fig. 12 Components on the minus socket
(1)
(14)
(15) (16)
(17)
(2)
(6)
(6)
(6)
(7)
(2)(3)
(1)
(8)
(8)