Fronius TransTig 800 Job User Manual

91
EN
NOTE!
Switching over from one job to the next without interrupting welding is only possible
with a JobMaster TIG welding torch, robot interface or field bus.
GPr
Gas pre-flow time
Unit s
Setting range 0 - 9,9
Factory setting 0,4
G-L
Gas-Low - gas post-flow time at minimum welding current
(minimum gas post-flow time)
Unit s
Setting range 0 - 25
Factory setting 5
G-H
Gas-High - Increase in the gas post-flow time at maximum welding current
Unit s
Setting range 0 - 40/Aut
Factory setting Aut
For further information on the G-H parameter, see the TIG set-up menu.
tAC
Tacking function: Duration of the pulsed welding current at the start of tacking
Unit s
Setting range OFF / 0.1 - 9.9 / ON
Factory setting OFF
For further information on the tAC parameter, see the TIG set-up menu.
F-P
Frequency-pulsing - Pulse frequency
Unit Hz / kHz
Setting range OFF / 0.20 Hz - 2.00 kHz
Factory setting OFF
For further information on the F-P parameter, see the TIG set-up menu.
dcY
Duty cycle - The ratio of pulse duration to base current duration when a pulse frequency
has been set
Unit %
Setting range 10 - 90
Factory setting 50

Fronius TransTig 800 Job Specifications

General

Brand	Fronius
Model	TransTig 800 Job
Category	Portable Generator
Language	English