Fuji Xerox DocuCentre-II 3005

Transmission Options
143
Fax
4
Example of specifying a destination:
F Code (sub-address) : 0 (to designate an F Code transmission) and the
mailbox number of a mailbox on the remote machine
Password (if necessary) : The password of the mailbox
Private Polling (F Code Method)
When a mailbox is set on a remote machine, you can perform private polling for the
mailbox by specifying its F code (sub-address) and password (if set up).
If you use your machine to perform private polling for a mailbox on a remote machine,
obtain the F Code (sub-address) and password of the target mailbox.
If you use a remote machine to perform private polling for a mailbox on your machine,
give the following information.
F Code (sub-address) : 0 (to designate an F Code transmission) and the
mailbox number of the target mailbox
Password (if necessary) : The password of the target mailbox
Note • Mailbox reception using the DTMF method is possible, but the only signals that can be
received are numerals, ∗, and #.
• It may be possible to automatically print a document received in the mailbox depending on
the mailbox settings. For information about setting the mailbox, refer to "Mailbox" (P.334).
• Depending on the report print settings, the [Mailbox Report] may not be printed even if e-
mail is received in the mailbox. For information on setting the report print settings, refer to
"Reports" (P.282).
For information on printing received documents, refer to "Printing/Deleting Documents in the Mailbox"
(P.208).
Sending to Mailbox (F Code Method)
1 Select [F Code] on the
[Transmission Options] screen.
2 Select [On].
3 Use numeric keys to enter an F
code, and select [Next].
Note • An F code must be up to 20 digits.
4 If required, enter a password into [Password], and then select [Next].
Note • A password must be up to 20 digits.
Off
The F code transmission is not used.
On
The F code transmission is used. Enter the F Code.
F Code
Enter the F code using the numeric keypad.
Note • You can enter up to 20 digits for the F Code.
Password
Enter the password using the numeric keypad. If a password has not been set, you do
not need to enter one.
Note • You can enter up to 20 digits for the password.