Job Assembly
91
Copy
3
Job Assembly
On the [Job Assembly] screen, you can configure features such as Build Job and
Sample Set. The following shows the reference section for each feature.
Build Job (Making Copies of Documents with Different Settings in a Single Operation)........ 91
Sample Set (Checking the Finished Output of the Copy) .......................................................... 93
Combine Original Sets (Adding Originals)................................................................................ 94
Form Overlay (Making Copies to Overlay Documents)............................................................ 95
Delete Outside/Delete Inside (Deleting Outside or Inside of the Selected Area) ..................... 96
1 On the [All Services] screen, select
[Copy].
2 Select the [Job Assembly] tab and
then select a feature on the [Job
Assembly] screen that appears.
Build Job (Making Copies of Documents with Different Settings in a
Single Operation)
This feature allows you to change and save settings individually for each document
page or stack and then to finally make copies of documents with different settings as
one job.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
1 Select [Build Job].
2 Select [On].
3 Select the desired print settings.
Note • Select [ ] to return to the previous screen or [ ] to move to the next screen.
îš„Off
Build Job is not applied.
îš„On
Build Job is applied. The feature buttons appear. Set any item if necessary.
For the features that can be set here, refer to "Copy Output (Outputting by Specifying Finishing)" (P.75).
Features that can be set in Build Job
îš„Copy Output
For information on the feature, refer to "Copy Output (Outputting by Specifying Finishing)" (P.75).
To Next Page
Loading...
Need help?
General
