Broadcast
153
Fax
4
Fax Signal Method
1 Select an address number or group dial number to which a relay broadcast is
registered and press the <Start> button.
To perform Multiple Relay Broadcast, repeat this step.
DTMF Method
There are two methods in the DTMF method: Auto Send and Manual Send.
Auto Send (transmitting without picking up the receiver)
1 Select [Keyboard] to display the keyboard on the touch screen and enter the following
format.
2 Select [Next Recipient] to perform Multiple Relay Broadcast.
Note • You can specify up to 20 locations for relay recipients.
z
Password
A pre-registered two-digit number
Note • By default, no password is set. For setting a password, contact our Customer Support
Center. If a password has not been set, you do not need to enter one.
z
Relay station ID
The last two digits of the initiating station address number registered at the relay
station.
z
Address number
An address number for the relay recipients registered at the relay station.
The wildcard "∗" can also be used.
Note • The above dialing format can be registered in an address number to send using the address
number. For information on how to register address numbers, refer to "Address Book"
(P.343).
3 Press the <Start> button.
Manual Send (transmitting with picking up the receiver or on-hook)
1 Select the [Advanced Features] tab
to display the [Advanced Features]
screen.
2 Select [On-hook (Manual Send/
Receive)].
3 Select [Manual Send] from the
drop-down menu.
4 Use the keyboard shown in the
touch screen to enter numbers in
the following format.
To Next Page
Loading...
