Fuji Xerox DocuCentre-II 3005 User Manual

System Administrator Settings
351
System Settings
11
System Administrator Settings
In [System Administrator Settings], you can set the system administrator ID and
passcode.
You are recommended to set the system administrator ID and passcode to prevent
setting changes and ensure security.
The following shows the reference section for each item.
System Administrator Login ID............................................................................................... 351
System Administrator’s Passcode ............................................................................................ 351
Maximum Login Attempts....................................................................................................... 352
1 In the [System Settings] screen, select [System Administrator Settings].
For the method of displaying the [System Settings] screen, refer to System Settings Procedure (P.258).
2 Select any item.
System Administrator Login ID
Set the system administrator user ID. Enter the ID from 1 to 32 characters.
Note • The default of the system administrator user ID is “11111”.
1 Select [System Administrator Login
ID].
2 Select [On].
3 Select [Keyboard], then in [New
System Administrator Login ID],
enter the system administrator ID, and select [Save].
4 Select [Keyboard] once more, and in [Re-enter System Administrator Login ID], enter
the same system administrator ID, and select [Save].
5 Select [Save].
6 A confirmation window appears. Select [Yes] to confirm your entry.
System Administrator’s Passcode
Set the passcode for System Administration mode.
Setting a passcode is strongly recommended for security.
Note • The default of the system administrator’s passcode is “x-admin”.
The system administrator’s passcode becomes valid when [Passcode Entry from Control
Panel] in [Login Setup/Auditron Administration] is [On].
Set the passcode after setting the system administrator User ID.
You can set the passcode from 4 to 12 numeric digits.
For information about enabling and disabling passcodes, refer to Passcode Entry from Control Panel
(P.359).
1 Select [System Administrator’s
Passcode].
2 Select [Keyboard].

Fuji Xerox DocuCentre-II 3005 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-II 3005
Category	All in One Printer
Language	English