ESC/P Emulation
549
Appendix
17
ESC/P Emulation Print Features
Multiple-Up
The multiple-up feature reduces the size of multiple-sheet documents and prints them
on a single sheet of paper.
The multiple-up feature can be used in the ESC/P emulation mode. In the ESC/P mode,
2 Up can be used.
Form Overlay
In the ESC/P mode, you can register an original form to the printer, and overprint it on
a printed output.
A form to be overprinted can be specified on the control panel.
Barcodes
In the ESC/P mode, you can use barcodes. The barcodes that can be used are as
follows.
z
JAN code
z
CODE39
z
CODABAR
z
Industrial 2 of 5
z
Industrial 2 of 5
z
Interleaved 2 of 5
Forms
You can use ESC/P to register forms on the machine. Up to 64 forms can be registered.
ESC/P Emulation Settings
The following tables show the basic and extended settings that can be configured on
the ESC/P emulation mode menu.
Basic Settings
Setting Item
Item
Number
Value
Paper tray 3 Sets the paper tray to be used for printing.
[0] : Auto
[1] (Default) : Tray 1
[2] : Tray 2
[3] : Tray 3
[4] : Tray 4
[5] : Tray 5 (Bypass)
If printing from Tray 5 (Bypass), instruct printing and then operate the
machine to start printing. To cancel the setting, change the setting for
"Tray 5 Confirmation".
Important• When Tray 1, 2, 3, or 4 is selected, the size of paper loaded in the
tray becomes the output paper size, and thus [Paper Size] cannot be
set.
Note • When [Auto] is selected, and if the paper of the same size is loaded in
the same orientation in multiple trays, paper will be supplied in the
order of Tray 1 J Tray 2 J Tray 3J Tray 4. If paper of the same size
is loaded in multiple trays but in different orientations, the paper
loaded in the landscape orientation is given priority.
To Next Page
Loading...
Need help?
General
