Common Settings
291
System Settings
11
Service Rep. Restricted Operation
This feature protects the Security Kit settings from being altered by an outsider pretending to
be our customer engineer. Select whether to permit our customer engineer to perform
[Overwrite Hard Disk] and [Data Encryption] operations, and to change the [HTTP - SSL/
TLS], [System Administrator Login ID], [System Administrator’s Passcode], and [Maximum
Login Attempts] settings. Make sure not to lose the system administrator’s user ID and
passcode. Otherwise, the various settings that are only available in system administrator
mode cannot be changed. If the system administrator’s user ID and passcode are lost when
[Service Rep. Restricted Operation] is set to [On], not only you but also we are no longer able
to change any setting in system administrator mode. If you lose the system administrator’s
user ID and passcode when the Security Kit is installed, the electric component board of the
machine must be replaced in order to change any setting in system administrator mode. In
that case, you will be charged for the electrical component board and handling cost.
Note • An optional package is required to use this feature. For more information, contact our
Customer Support Center.
Software Download
This feature is for customer engineer use. For more information, contact our Customer
Support Center.
Recipient Selection Method
Set whether to place restrictions on fax, iFax, or e-mail transmissions to addresses
unregistered on Address Book.
Selecting [Only From Address Book] disables address entry on the [Fax], [iFax], or [E-mail]
screen using the keyboard or numeric keypad, and permits only transmissions to addresses
registered on Address Book.
To Next Page
Loading...
Need help?
General
