EasyManuals Logo
Home>Fuji Xerox>All in One Printer>DocuCentre-II 3005

Fuji Xerox DocuCentre-II 3005 User Manual

Fuji Xerox DocuCentre-II 3005
615 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #466 background imageLoading...
Page #466 background image
16 Problem Solving
464
Problem Solving
16
Error Code
This section explains error codes.
If an error caused printing to end abnormally, or a malfunction occurred in the machine,
then an error message code (∗∗∗-∗∗∗) is displayed.
Error codes for fax are written also in job status/activity reports and unsent reports.
For information on job status/activity reports and transmission reports (undelivered), refer to "Activity
Report" (P.388) and "Report / Read Receipts (Confirming Transmission Results)" (P.131) respectively.
Refer to the following table for error codes to rectify problems.
Important • If an error code is displayed, any print data remaining on the machine and information stored
in the machine's memory is not warranted.
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, contact our Customer Support Center. The contact number
is printed on the label or card attached on the machine.
Errors are classified into the following categories.
C: Copy
P: Print
F: Fax
S: Scan
M: Mail
O: Others
Error Code
Category
Cause and Remedy
CPFSMO
002-770
O O [Cause] Unable to process the job template due to insufficient hard
disk space.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
003-701
O O [Cause] A digital code is embedded in the document to restrict
duplication.
[Remedy] Use a document that no digital code is embedded in.
003-750
O [Cause] Unable to store any documents using the 2-Sided Book
Copy feature.
[Remedy] Check the 2-Sided Book Copy settings.
Refer to "2 Sided Book Copy (Making 2 Sided Copies of Facing Pages)"
(P.67).
003-751
O O [Cause] Unable to process, because the specified document area
is too small.
[Remedy] Increase the resolution or scan area.
003-752
O [Cause] The mixed sized document was to be scanned at 600dpi
with 2 Sided.
[Remedy] Set [Scan Resolution] to [400dpi] or lower, and try again.
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.

Table of Contents

Other manuals for Fuji Xerox DocuCentre-II 3005

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre-II 3005 and is the answer not in the manual?

Fuji Xerox DocuCentre-II 3005 Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuCentre-II 3005
CategoryAll in One Printer
LanguageEnglish

Related product manuals