5 Scan
170
Scan
5
Step 3 Starting the Scan Job
1
Press the <Start> button.
Important • If the document has been set
in the document feeder, do not
hold down the document while
it is being conveyed.
• Scanning cannot be
performed if a copy protection
code is detected.
Note • If a problem occurs, an error
message appears in the touch
screen. Solve the problem in accordance with the message.
• The next scan job can proceed while scanning.
If you have more documents
If you have another document, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to scan multiple documents as a
set of data.
Up to 999 pages can be stored.
Note • If the number of document pages exceeds this maximum, then scanning stops. Follow the
displayed message, and either abort the operation, or save the scanned document data.
2 While documents are being
scanned, select [Next Original].
Note • When the screen at right is
displayed and no operation is
performed during a certain
period of time, the machine
automatically assumes that
there are no more documents.
• When using the document feeder, load the next document after the machine has finished
scanning the first document.
• You can change the scan settings of the next document by selecting [Change Settings]
displayed after selecting [Next Original].
3 Load the next document.
4 Press the <Start> button.
If you have more documents, repeat Steps 3 and 4.
5 When all documents have been
scanned, select [Last Original].
123
456
789
0 #
C
<Start> button
To Next Page
Loading...
