3 Copy
92
Copy
3
îš„Booklet Creation
For information on the feature, refer to "Booklet Creation (Creating a Booklet)" (P.77).
îš„Covers
For information on the feature, refer to "Covers (Attaching a Cover to Copies)" (P.78).
îš„Annotation
For information on the feature, refer to "Annotation (Adding Stamp/Date/Page Number to Copies)"
(P.82).
îš„Watermark
For information about the feature, refer to "Watermark (Printing Control Number on the Background)"
(P.86).
[Copy Job] screen
The following describes the screen that appears while the Build Job is being executed.
îš„Chapter Start...
Displays the [Build Job - Chapter Start/Separators] screen.
Refer to "[Build Job - Chapter Start/Separators] Screen" (P.93).
îš„Change Settings...
The Copy screen appears and you can change the settings for the loaded document.
After setting the features, press the <Start> button on the control panel to start
scanning of the document.
îš„Last Original
Select this to end scanning of documents. The build job starts.
îš„Next Original
Select this when you have another document. This item is selected when using the
Build Job feature.
îš„Cancel
The document data stored by the Build Job feature is cleared and the job is cancelled.
Note • The same operation is performed if you press the <C (Clear)> button or <Clear All> button
on the control panel.
îš„Start
When loading the next document and select [Start], the next documents are scanned.
Note • The same operation is performed if you press the <Start> button on the control panel.
To Next Page
Loading...
Need help?
General
