11 System Settings
320
System Settings
11
Mixed Sized Originals Scan Mode
If only documents of the standard sizes are to be scanned, it is recommended that you select
[Standard Size Mode].
Important • When [Standard Size] is selected, image loss may occur if the following types of documents
are scanned:
- Non-standard size documents
- B4 size documents with the inch series setting in [Paper Size Settings]
Skip Blank Pages
Set whether to use the feature that detects blank sheets while scanning 2-sided documents
and transmits only documents whose surface is not blank.
Note • This feature is for customer engineer use. For more information, contact our Customer
Support Center.
Sender ID
For G3 communications, you can select whether to notify the G3-ID to recipients.
Save Undelivered Faxes
Set whether to save a fax document if fax transmission failed. When [Yes] is selected, the
[Undelivered Faxes] button appears on the [Stored Documents] tab of the [Job Status]
screen. Select this button to send the fax document again.
For details on [Undelivered Faxes], refer to Undelivered Faxes (P.375).
Save Cancelled Faxes
When [Yes] is selected for [Save Undelivered Faxes], set whether to also save cancelled fax
documents.
Saved Faxes - Auto Delete
When [Yes] is selected for [Save Undelivered Faxes], set whether to automatically delete
saved documents in 24 hours.
Transmission Interval
Specify a value for the interval between the end of one transmission and the beginning of the
next, from 3 to 255 seconds in 1 second increments.
A longer transmission interval increases the total time to send a broadcast transmission, for
example, but allows calls to be received during the standby time.
Batch Send
A batch send means that when multiple transmissions have been stored for the same
address, the documents are sent in a single transmission to the address, and this sets
whether or not to do this. When Batch Send is set, the communications cost can be reduced.
Select whether to use the batch send feature.
Note that a batch send is not possible for manual transmissions, broadcast, relay broadcast,
mailbox transmissions, and transmissions with a specified time before the specified time.
When using a redial, resend, or delayed start send transmission job or the authentication
feature, to send to the same address from different users, then a batch send is not possible.
Manual Send/Receive Default
When using on-hook or off-hook, set whether the initial state of the touch screen is [Manual
Send] or [Manual Receive].
To Next Page
Loading...
Need help?
General
