11 System Settings
326
System Settings
11
îš„Full Headers and Contents
Prints the e-mail headers and body of the e-mail. When you check a mark to [Print S/MIME
Information], S/MIME Information is also printed.
îš„Basic Headers and Contents
Prints a part of e-mail headers (From/To/Subject/Date) and the body contents.
îš„Auto Print
If [Auto Print] is enabled, prints out only when the e-mail has its contents.
Incoming iFax Output Destination
Set the output tray to be used for printed iFax documents.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Fax Transfer from Address Book
Set whether to set restrictions when forwarding e-mail received in SMTP format by iFax to fax
addresses not in the address book.
îš„Off
Forwarding is not restricted.
îš„On
Checks if the forwarding fax number is listed in the address book, and if not, refuses the
received e-mail and destroys the data.
Fax Transfer - Add Sender Header
When forwarding received e-mail from iFax to fax, select whether to add a send header (start
time, sender name, recipient name, G3 ID, and number of pages).
Fax Transfer Maximum Data Size
When sending a received e-mail from iFax to fax, set the maximum data size.
îš„No Limit
No limit on data size.
îš„Set Limit
Specify a value within the range from 1 to 65,535 KB, in 1 KB increments. If a data size
exceeds the specified value, the data is discarded.
To Next Page
Loading...
Need help?
General
