13 Machine Status
384
Machine Status
13
Programming
You can check or change the values set for the print mode item numbers.
For information on item numbers that can be set in the each emulation mode menus, refer to "Appendix"
(P.537).
For information on KS/KSSM emulation mode, refer to the User Guide for the Korean model. For
information on the ESCPK emulation mode, refer to the User Guide for the Traditional Chinese model
or Simplified Chinese model.
1 Select [Programming].
2 Enter the feature number to be set
in [Item Number] using the numeric
keypad.
3 Select [Confirm] as necessary.
4 Select [Change Value].
5 Enter [New Value] using the
numeric keypad.
6 Select [Save].
îš„Item number
Enter the item number of the feature to be set.
îš„Current Value
When you enter [Item Number], the currently set value appears.
îš„New Value
Enter a new value.
Store/Delete Programming
For ESC/P, HP-GL/2 emulations, you can register settings in the memory.
You can register up to 20 print modes for ESC/P and HP-GL/2 emulations.
1 Select [Store/Delete Programming].
2 Select [Store Current Selections] or [Delete].
3 Select the memory number to be stored or to be deleted.
îš„Store Current Selections
Stores the current selections. If you select a number already stored, its settings will be
overwritten with the new settings. The overwritten settings cannot be restored.
îš„Delete
When you select [Delete] and then select the number to be deleted, the number will be
deleted.
Important • The deleted numbers cannot be restored.
To Next Page
Loading...
Need help?
General
