ESC/P Emulation
551
Appendix
17
Extended Settings
Setting Item
Item
Number
Value
Paper position 20 Sets the paper position.
[0] (Default) : Without cut sheet feeder (left)
[1] : With cut sheet feeder (center)
Note • When a continuous form paper is selected for [Original Size], [Paper
Position] cannot be set.
Output quantity 8 Sets the number of copies to be printed.
[1 to 250] (Default: 1): 1-250 copies
Important• When the output quantity is specified by a client, the copies of that
set of number will be printed. After printing, the number set on the
control panel will be changed to that number. However, the number
of copies specified from NetWare or lpd port will not change the
number set on the control panel.
Reduce/enlarge 54
(Reduce/
enlarge mode)
Sets the print magnification.
[0] (Default) : Preset %
[1] : Variable %
[2] : Fit to Cut Sheet
[Preset %] is a magnification calculated automatically based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
original to fit to the printable area of the output paper. Therefore, if the
size of the original and that of the output paper are the same, the
magnification will be 100%. Also, if [2 Up] is selected, the original will be
reduced to the size where two pages fit into one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/
Enlarge]. A reference point for scaling (reducing/enlarging) is the upper
left corner of the printable area. This reference point applies to all text,
images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area to the printable area of
the output paper. It is a magnification calculated automatically based on
[Original Size] and [Paper Size], and reduces/enlarges the whole original
(including the area outside of the printable area) to fit to the printable
area of the output paper.
17
(Variable %/
vertical
magnification)
Sets the magnification for the vertical or horizontal direction.
[45 to 210] (Default:100):45-210%
Note • When a continuous form paper is selected for [Original Size], both
[Preset %] and [Fit to Cut Sheet] produce the same print result.
18
(Variable %/
horizontal
magnification)
2 Up mode 21 Sets whether to print in 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the
other.
[0] (Default) : Off
[1] : Reverse
[2] : Forward
Important• When [Landscape] is selected for [Original Size], [Forward] or
[Reverse] produce the same print result.
To Next Page
Loading...
Need help?
General
