Supplies
111
Machine Status
4
Supplies
You can check the status of consumables on the [Supplies] screen. The status of
consumables is shown as "OK", "Replace Soon (Order Now)", or "Replace Now".
The following describes the procedure to check the status of consumables.
For information on replacing consumables, refer to "Maintenance" (P.53).
1 Press the <Machine Status> button.
2 Select the [Supplies] tab and confirm the
status of the toners.
Note • Pressing a supply name displays a
screen about the status of the supply.
3 Select [Toner] from the drop-down list box,
and then select [Other Consumables] and
confirm the status of the consumables.
On the [Supplies] screen, you can check the following items:
Important • If you replace a toner cartridge with a partially used toner cartridge, the displayed status may
differ from the actual remaining amount. When you replace toner cartridges, we recommend
that you use new ones.
Note • Pressing a supply name displays a screen about the status of the supply.
• The items displayed vary depending on the options installed.
• Select [ ] to display the previous screen or [ ] to display the next screen.
• Select the [Reset Counter] button after you replaced the 2nd BTR Unit or IBT Unit.
z
Black Toner [K]
z
Waste Toner Container [R5]
z
Cyan Toner [C]
z
Fuser Assembly [R8]
z
Magenta Toner [M]
z
Staple Cartridge [R1]
z
Yellow Toner [Y]
z
Booklet Staple Cartridge [R2]
z
Drum Cartridge [R1]
z
Booklet Staple Cartridge [R3]
z
Drum Cartridge [R2]
z
Hole Punch Waste Container [R4]
z
Drum Cartridge [R3]
z
Second Bias Transfer Roll [R7]
z
Drum Cartridge [R4]
z
Transfer Belt [R6]
To Next Page
Loading...
Need help?
General
