Fuji Xerox DocuCentre-IV C2260

Configuration of Store to USB
297
Scanner Environment Settings
9
Configuration of Store to USB
This section describes how to configure the machine to use the Store to USB service.
The following shows the reference section for each procedure.
Step 1 Preparations................................................................................................................... 297
Step 2 Enabling USB Port........................................................................................................297
CentreWare Internet Services Setting Items ............................................................................ 298
Step 1 Preparations
The Store to USB service allows you to directly save the scanned data to a USB 2.0
memory device which is inserted into the USB memory slot on the control panel of the
machine.
Available USB Memory Devices
z
USB 2.0 memory devices
z
USB memory devices with the capacity of up to 128 GB
z
USB memory devices that support FAT12, FAT16, FAT32, or VFAT (long name)
Note • USB memory devices that are encrypted with software cannot be used with the machine.
Step 2 Enabling USB Port
To use Store to USB service, enable the USB port. The following describes the
configuration procedures on the machine.
Note • You can configure the settings using CentreWare Internet Services. For information on how
to use CentreWare Internet Services, refer to "Configuring Machine Settings Using
CentreWare Internet Services" (P.259).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the USB port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [USB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3 Select [Close] repeatedly until the [Tools] screen is displayed.
4 Select [Close].