Connectivity & Network Setup
167
Tools
5
Connectivity & Network Setup
In [Connectivity & Network Setup], you can configure settings related to the
Connectivity & Network feature.
For information on Connectivity and Network Settings, refer to "Printer Environment Settings" (P.263)
or "E-mail Environment Settings" (P.281).
If you use CentreWare Internet Services, more detailed settings are possible. For more information, refer
to "CentreWare Internet Services Settings" (P.255).
The following shows the reference section for each setting.
Port Settings ............................................................................................................................. 167
Protocol Settings ...................................................................................................................... 171
Machine’s E-mail Address/Host Name.................................................................................... 174
Proxy Server Settings............................................................................................................... 174
Outgoing/Incoming E-mail Settings......................................................................................... 175
Remote Authentication/Directory Service ............................................................................... 176
Security Settings....................................................................................................................... 181
Other Settings........................................................................................................................... 184
1 On the [Tools] screen, select [Connectivity & Network Setup].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.116).
2 Select an item to set or change.
Port Settings
Set the interface of the machine connected to a client. In [Port Settings], you can
configure the following settings.
Important • For LDP, Port9100, and HTTP-SSL/TLS, do not use a number that is the same as a port
number of another port.
For a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)), do not use a number that is the same as a
port number of LPD, Port9100, and HTTP-SSL/TLS.
Furthermore, if any of the above are set to one of the port numbers indicated below,
operation may no longer be performed properly depending on the setting conditions of the
port:
25, 139, 427, 445, 631, 15000
For information on HTTP-SSL/TLS port, refer to "HTTP - SSL/TLS Port Number" (P.181).
USB
îš„Port Status
Select [Enabled] to use a USB interface.
îš„Print Mode
Select the printer language use on the machine. Selecting [Auto] enables the machine to
automatically determine and use the most suitable language to print data received from the
host device.
îš„PJL
PJL (Printer Job Language) is a job control language and a PJL command is data prepended
to the top of the print jobs. Usually select [Enabled].
To Next Page
Loading...
Need help?
General
