Replacing Consumables
69
Maintenance
3
Important • Empty the hole punch waste container when the machine is on. If you empty the container
while the machine is off, the machine does not recognize that the container has been
emptied.
1 Make sure that the machine is not operating,
lift the top transport cover, and then open the
front transport cover of the finisher.
2 Pull out the hole punch waste container.
3 Empty the container.
4 Insert the emptied hole punch waste
container into the finisher until it stops.
5 Close the front transport cover, and then close the top transport cover of the finisher.
Note • If the cover is not completely closed, a message will appear and the machine remain
paused.
Replacing Stamp
If the machine offers the Fax service and the Stamp Kit (optional) is installed, replace
the stamp cartridge when stamp impressions start to fade.
Important • Do not touch the ink pad of the stamp cartridge as the ink may be adhered to the pad. If it
comes into contact with your skin, wash immediately.
To Next Page
Loading...
Need help?
General
