Common Service Settings
149
Tools
5
Notify Job Completion by E-mail
You can receive the results of jobs performed, by an e-mail notification.
îš„Targeted Jobs
Select the service whose job result you want to receive by an e-mail notification. When
the target job is already selected, [Selected] is displayed.
You can select more than one target job from [Copy], [Fax], [Scan], [Print], or [Report].
Select the notification timing from [Notify at the End of Job] or [Notify when Error Only].
îš„E-mail Addresses 1 to 5
Specify the e-mail addresses to notify the result of the jobs.
Note • When you select [Save] without specifying an e-mail address, the setting of [Targeted Jobs]
or [E-mail Message] is deleted.
îš„E-mail Message
Enter a comment attached to the e-mail.
Other Settings
You can configure other settings related to the machine.
Fax Service
Switches between the Fax feature and the Server Fax feature.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• The Fax and Server Fax features cannot be enabled at the same time.
îš„Scan to Fax
Allows you to use the Fax feature on the machine.
îš„Scan to Fax Server
Allows you to use the Server Fax feature on the machine.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
Offset Stacking (Center Tray)
Offsetting means that each set of copies is delivered to the center tray and shifted slightly to
separate it from the previous job. When a set of copies is delivered to the front of the tray, the
next set is delivered to the rear of the tray. Set the offset function for the Center Tray - Lower.
Select from [No Offset], [Offset per Set], and [Offset per Job]. When [Offset per Set] or [Offset
per Job] is selected, the machine slightly shifts the output position per set or per job (print job)
respectively.
Offset Stacking (Center Tray - Lower)
Offsetting means that each set of copies is delivered to the center tray and shifted slightly to
separate it from the previous job. When a set of copies is delivered to the front of the tray, the
next set is delivered to the rear of the tray. Set the offset function for the Center Tray - Lower.
Select from [No Offset], [Offset per Set], and [Offset per Job]. When [Offset per Set] or [Offset
per Job] is selected, the machine slightly shifts the output position per set or per job (print job)
respectively.
To Next Page
Loading...
Need help?
General
