5 Tools
172
Tools
5
îš„DHCP
The address, subnet mask, and gateway address will automatically be set via DHCP.
îš„BOOTP
The address, subnet mask, and gateway address will automatically be set via BOOTP.
îš„RARP
The address, subnet mask, and gateway address will automatically be set via RARP.
îš„DHCP/Autonet
The address, subnet mask, and gateway address will automatically be set via DHCP/Autonet.
If the machine fails to communicate with the DHCP server, the AutoIP function is
automatically enabled and the machine is assigned an IP address (169.254.xxx.xxx). When
communication between the machine and the DHCP server recovers, the machine is re-
assigned an IP address, a subnet mask, and a gateway address by the DHCP server.
îš„STATIC
Allows you to manually specify an IP address, a subnet mask, and a gateway address.
Note • To configure a subnet mask and a gateway address, an IP Address must be set first.
IPv4 - IP Address
Enter the IP address using the keyboard displayed or the numeric keypad when selecting
[STATIC] at [IPv4 - IP Address Resolution].
Note • Enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from of 0 to
255.
• Specify an IP address using numbers (0 to 9) and periods (.). If you mistyped a character on
the screen, select [Backspace] to delete the character.
IPv4 - Subnet Mask
Enter the subnet mask using the keyboard displayed or the numeric keypad when selecting
[STATIC] at [IPv4 - IP Address Resolution].
Note • Enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from of 0 to
255.
• Specify a subnet mask using numbers (0 to 9) and periods (.). If you mistyped a character on
the screen, select [Backspace] to delete the character.
IPv4 - Gateway Address
Enter the gateway address using the keyboard displayed or the numeric keypad when
selecting [STATIC] at [IPv4 - IP Address Resolution].
Note • Enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from of 0 to
255.
• Specify a gateway address using numbers (0 to 9) and periods (.). If you mistyped a
character on the screen, select [Backspace] to delete the character.
IPv4 - DNS Server Setup
Set the DNS server.
îš„Get IP Address from DHCP
Set whether or not to automatically obtain the address of the DNS server from the DHCP
server.
îš„DNS Server IP Address
When [Get IP Address from DHCP] is set to [Disabled], manually set the DNS server
address.
IPv4 - IP Filter
Select whether or not to limit IPv4 addresses that can access the machine.
To Next Page
Loading...
Need help?
General
