Description of Menu Items
9-12
Parallel Settings
Specifies the settings for the parallel interface.
Note: You need to restart the printer to activate the new settings. After changing the settings, turn off the
printer and then turn it on again.
ECP
Specifies if the ECP communication mode of the parallel interface is enabled or disabled.
Adobe Protocol
Use Adobe Protocol menu to specify PostScript communication protocol for the parallel interface. Restart
the printer after making changes in the menu.
■ TBCP: Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code. Default setting.
■ Binary: Used when no special processing is required for data.
■ Auto: Used when auto-detecting the PostScript communication protocol.
■ Standard: Used when the communication protocol is in ASCII interface.
■ BCP: Used when the communication protocol is in binary format.
USB Settings
Use the USB Settings menu to change printer settings affecting the USB port.
Adobe Protocol
Use Adobe Protocol menu to specify PostScript communication protocol for the USB interface. Restart the
printer after making changes in the menu.
■ Auto: Used when auto-detecting the PostScript communication protocol.
■ Standard: Used when the communication protocol is in ASCII interface.
■ BCP: Used when the communication protocol is in binary format.
■ TBCP: Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code. Default setting.
■ Binary: Used when no special processing is required for data.
Fax Settings
The Fax Settings menu contains the following items.
■ Interval Timer: Specifies the interval time between resend attempts.
■ Number of Redial: Specifies the number of redial attempts.
■ Int. of Redial: Specifies the time between redial attempts.
■ Ans Select: Specifies the receiving mode:
To Next Page
Loading...
Need help?
General
