Description of Menu Items
9-13
■ TEL Mode: Automatic fax reception is turned off. You can receive a fax by picking up the handset
of the external phone and then pressing the remote receive code, or by setting OnHook to On (you
can hear voice or fax tones from the remote machine) and then pressing Start.
Note: Before turning the printer off and on, if the TEL Mode is selected among the FAX Mode,
TEL/FAX Mode, the printer does not retain the TEL Mode after turning back on. It will go back to
whatever the mode previously selected before switching to the TEL Mode (either Fax Mode or
TEL/FAX Mode).
■ FAX Mode: A fax is automatically received.
■ TEL/FAX Mode: When the printer receives an incoming fax, the external telephone rings for the
time specified by Auto Ans. TEL/FAX, and then the printer automatically receives the fax. If
incoming data is not a fax, the printer beeps the internal speaker.
■ Ans/FAX Mode: The printer can share one telephone line with an answering machine. In this
mode, the printer will monitor the fax signal and pick up the line if there are fax tones. If the phone
communication in your country is serial, this mode is not available.
■ DRPD Mode: Before using the Distinctive Ring Pattern Detection (DRPD) option, distinctive ring
service must be installed on your telephone line by the telephone company. After the telephone
company has provided a separate number for faxing with a distinctive ring pattern, configure the
fax setup to monitor for that specific ring pattern.
■ Auto Answer Fax: When FAX Mode is enabled, specifies how long the printer waits before answering
an incoming call. Values range from 0 to 255 seconds.
■ Auto Ans. TEL/FAX: When TEL/FAX Mode is enabled, specifies how long the printer waits before
answering an incoming call. Values range from 0 to 255 seconds.
■ Auto Ans. Ans/FAX: When ANS/FAX Mode is enabled, specifies how long the printer waits before
answering an incoming call. Values range from 0 to 255 seconds.
■ Line Monitor: Specifies the volume of the external phone (line monitor).
■ Ring Tone Volume: Specifies the volume for the incoming faxes.
■ Line Type: Specifies the default line type.
■ Dialing Type: Specifies the dialing type.
■ Junk Fax Filter: When set to On, incoming faxes are only accepted from numbers registered in the
Address Book.
■ Remote Receive: Specifies whether to receive a fax by pressing the remote receive code on the
external telephone after picking up the handset of the telephone. When set to On, a fax can be received
by pressing the remote receive code on the external telephone.
■ Remote Rcv Tone: Specifies the tone in two digits (00-99) when Remote Receive is set to On.
■ Duplex Print: Specifies duplex printing when receiving a fax. This option is only available when the
printer has a duplex unit installed.
■ Send Header: When set to On, the sender record is printed at the head of the fax.
■ Company Name: Specifies the sender name to be recorded in the sender report.
■ Yo u r F a x Nu m b er : Specifies your telephone number, which is printed at the top of each page sent
from your printer.
■ Device Name: Specifies your name or your company name, which is printed on the report sheet.
To Next Page
Loading...
Need help?
General
