132 Printing Basics
4 Before loading the print media, flex the sheets back and forth, and then fan them. Straighten the
edges of the stack on a level surface.
5 Load print media on the PSI with the top edge first and with the recommended print side facing
up.
6 Adjust the paper width guides until they rest lightly against the edges of the stack of print media.
7 Select the paper type from the print driver if the loaded print media is not plain paper. If a user-
specified print media is loaded in the PSI, you must specify the paper size setting by using the
print driver.
NOTE:
• For more information about setting the paper size and type on the print driver, refer to the Help provided for
the print driver.
To Next Page
Loading...
Need help?
General
