314 Using the Operator Panel Menus and Keypad
• Auto Reset
Purpose:
To automatically reset the settings for copying, scanning, or faxing to the defaults and return to the
standby mode after you do not specify any settings for the specified time. (The fax feature is available
only on the DocuPrint CM215 f/CM215 fw.)
Values:
•Fault Time-Out
Purpose:
To specify the time taken by the printer before it cancels jobs that stop abnormally. The job is
cancelled if it times out.
Values:
• Job Time-Out
Purpose:
To specify the amount of time that the printer waits for data to arrive from the computer. The print job is
cancelled if it times out.
Values:
•Date & Time
Purpose:
To set the date and time, and regional time zone of the printer.
Values:
45sec*
1min
2min
3min
4min
Off Disables the fault time-out.
On 60sec* Specifies the time taken by the printer before it cancels for jobs
that stop abnormally.
3–300sec
Off Disables the job time-out.
On 30sec* Specifies the amount of time that the printer waits for data to
arrive from the computer.
5–300sec
Set Date Specifies the current date.
Set Time Specifies the current time.
Date Format yy / mm / dd Specifies the date format.
mm / dd / yy
dd / mm / yy*
To Next Page
Loading...
