86 Printer Connection and Software Installation
Configuring Printer and Installing Software on
Windows
This section includes:
• "Identifying Print Driver Pre-install Status (for Network Connection Setup) (DocuPrint CM215
f/CM215 fw Only)" on page 86
• "Using Installer to Set Up Connection and Install Software" on page 88
• "Using Installer to Install Software for the Existing Printer" on page 92
• "Setting Up for Web Services on Devices (WSD)" on page 93
• "Setting Up for Shared Printing" on page 96
îš„ Identifying Print Driver Pre-install Status (for Network
Connection Setup) (DocuPrint CM215 f/CM215 fw Only)
Before installing the print driver on your computer, check the IP address of your printer and change
the firewall settings.
This section includes:
• "Checking the IP Address for Your Printer" on page 86
• "Changing the Firewall Settings Before Installing Your Printer" on page 87
Checking the IP Address for Your Printer
1 Press the (System) button.
2 Select Report / list, and then press the button.
3 Select System Settings, and then press the button.
The System Settings page is printed.
4 Find the IP address under Network Setup/Wireless Setup on the System Settings page.
If the IP address is 0.0.0.0, wait for a few minutes to resolve the IP address automatically, and
then print the System Settings page again.
If the IP address is not resolved automatically, see "Assigning an IP Address Manually" on
page 82.
To Next Page
Loading...
Need help?
General
