Using the Operator Panel Menus and Keypad 343
Resetting to Factory Defaults
After executing Initialize NVM and rebooting the printer, the menu parameters or data are reset to
their factory default values.
NOTE:
• The following procedure does not initialize the network settings.
– For the DocuPrint CM215 f/CM215 fw, to initialize the network settings, refer to "Initialize NVM" on page 305.
– For the DocuPrint CM215 fw, to initialize the wireless network settings, refer to "Reset Wireless (DocuPrint
CM215 fw Only)" on page 303.
1 Press the (System) button.
2 Select Admin Menu, and then press the button.
3 Select Maintenance, and then press the button.
4 Select Initialize NVM, and then press the button.
5 Select System Section to initialize the menu parameters, and then press the button.
For the DocuPrint CM215 f/CM215 fw, select User Fax Section to initialize the Address Book
data for fax, and select User Scan Section to initialize the Address Book data for e-mail.
6 Select Yes, and then press the button.
The printer restarts automatically to apply the settings.
To Next Page
Loading...
