282 Faxing (DocuPrint CM215 f/CM215 fw Only)
Using an Answering Machine
You can connect a telephone answering device (TAD) directly to the rear of your printer as shown
above.
• Set your printer to Ans Machine/Fax and set Auto Rec Ans/FAX to specify the time for the
TAD to respond.
• When the TAD picks up the call, the printer monitors and takes the line if fax tones are received
and then starts receiving the fax.
• If the answering device is off, the printer automatically goes into the fax receive mode after the
ring tone sounds for a predefined time.
• If you answer the call and hear fax tones, the printer will answer the fax call if you
– Set OnHook to On (you can hear voice or fax tones from the remote machine), and then
press the (Start) button and hang up the receiver.
– Press the two-digit remote receive code and hang up the receiver.
To t he
wall jack
Printer
Line
Telephone Answering Device
Phone
To Next Page
Loading...
