Fuji Xerox DocuPrint CM215 series - Power on Wizard; Paper Density

316 Using the Operator Panel Menus and Keypad
• mm / inch
Purpose:
To specify the measurement unit displayed after the numeric value on the operator panel.
Values:
• Low Toner Alert Msg
Purpose:
To specify whether to show the alert message when the toner is low.
Values:
• Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
• "Setting Initial Settings on the Operator Panel" on page 52
Values:
Maintenance
Use the Maintenance menu for maintenance work including initialization of the NVM (non-volatile
memory).
NOTE:
• Asterisk (*) is the factory default setting.
• F/W Version
Purpose:
To display the version of the controller.
• Paper Density
Purpose:
To adjust the paper type.
Values:
Millimeters (mm)* Specifies the default measurement unit.
Inches (")
Off Does not show the alert message when the toner is low.
On* Shows the alert message when the toner is low.
Yes Performs the initial settings for the printer.
No* Does not perform the initial settings for the printer.
Plain Lightweight
Heavyweight*