306 Using the Operator Panel Menus and Keypad
• Receive Mode
Purpose:
To select the default fax receiving mode.
Values:
• Auto Rec Fax
Purpose:
To set the interval at which the printer goes into the fax receive mode after receiving an incoming call.
The interval can be specified within the range of 0 to 255 seconds. The default is 0 second.
• Auto Rec TEL/FAX
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external telephone
receives an incoming call. The interval can be specified within the range of 0 to 255 seconds. The
default is six seconds.
• Auto Rec Ans/FAX
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external answering
machine receives an incoming call. The interval can be specified within the range of 0 to 255 seconds.
The default is 21 seconds.
Telephone Automatic fax reception is turned off. You can receive a fax by picking
up the handset of the external telephone, pressing the remote receive
code, and then pressing (
Start
) button.
Fax* Automatically receives faxes.
Telephone/Fax When the printer receives an incoming fax, the external telephone
rings for the time specified in Auto Rec TEL/FAX, and then the
printer automatically receives a fax. If an incoming call is not a fax,
the printer beeps from the internal speaker indicating that the call is a
telephone call.
Ans Machine/Fax The printer can share a telephone line with an answering machine. In
this mode, the printer will monitor the fax signal and pick up the line if
there are fax tones. If the phone communication is using serial
transmission in your region, this mode is not supported.
DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a
separate number for faxing with a distinctive ring pattern, configure
the fax setup to monitor for that specific ring pattern.
To Next Page
Loading...
Need help?
General
