140 Printing Basics
Loading Print Media in the Priority Sheet Inserter (PSI)
1 First print the even pages (back sides).
For a six page document, back sides are printed in the order page 6, page 4, then page 2.
The (Data) LED blinks and the Insert Output to Tray message appears on the LCD
panel when the even pages finish printing.
2 After the even pages are printed, remove the paper stack from the center output tray.
NOTE:
• Warped or curled prints can cause paper jams. Straighten them before setting them.
3 Stack the prints and set them as they are (with the blank side face up) into the PSI, and then
press the button.
Pages are printed in order of page 1 (back of page 2), page 3 (back of page 4), and then page 5
(back of page 6).
NOTE:
• Printing on both sides of the paper is not possible if the document consists of various sizes of paper.
To Next Page
Loading...
Need help?
General
