Safety Notes 21
Others
Do not incline the product at more than 10 degree angle. Otherwise, it may fall over and cause
injuries.
The illustrations show the DocuPrint CM215 f/CM215 fw.
To bundle wires and cables, always use the cable ties and spiral tubes that Fuji Xerox supplies.
Otherwise, it may cause some defects.
To keep this product in a good performance and condition, always use it in the following
environment:
• Temperature: 10 – 32 °C
• Humidity: 10 – 85%
When the product is left in a chilly room and the room is rapidly warmed up by heater, dew
condensation may form inside the product and cause a partial deletion on printing.
10° 10°
10° 10°
Left
Front
Right
Back
Left
Front
Right
Back
To Next Page
Loading...
