User Guide
38
2.5 Setting the IP Address
2.5.1 Assigning the IP Settings to the Printer
You need to assign an IP address, subnet mask (for IPv4 only), and gateway address to the printer before using
it in a network environment.
The printer offers IPv4, IPv6, and dual stack connectivity. If your network supports both IPv4 and IPv6, select the
dual stack mode.
• Assigning an IP address that is already in use can cause network performance issues.
• IP addresses should be assigned by advanced users or system administrators.
• When you assign an IP address manually in IPv6 mode, use the printer installer or CentreWare Internet Services. For
details about how to start CentreWare Internet Services, see "Starting CentreWare Internet Services (P.61)."
Using the Printer Installer (Windows
®
Only)
1.
Insert the "Software/Product Manual" disc into your computer.
2.
Click [Support Tools].
3.
Click [Configure the IP address settings.].
4.
Follow the on-screen instructions until the [Configure Printer] screen appears.
5.
Click [Advanced].
6.
Specify the IP address settings, and then click [Next].
7.
Follow the on-screen instructions to complete the setup.
Using the Operator Panel
1.
Press the <Menu> button.
2.
Press the or button to select [Administrator Menu], and then press the button.
• If [Panel Lock] is enabled, enter the password. For details about this setting, see "Panel Lock (P.41)."
3.
Press the or button to select [Network Setup], and then press the button.
4.
Press the or button to select [TCP/IP], and then press the button.
5.
Press the or button to select [IP Mode], and then press the button.
To Next Page
Loading...
Need help?
General
