3 Using Your Printer
75
3.6.4 Loading Envelopes
• You can load envelopes only in the bypass tray and tray1.
• The label on the bypass tray shows how to load print media and envelopes for printing.
• Use only freshly unpackaged and undamaged envelopes.
If you do not load envelopes right after they have been removed from the package, they may bulge. To avoid jams,
press firmly across the whole envelopes to flatten them as shown in the illustration before loading the envelopes.
• Use only same size envelopes for a single print job.
• The maximum height (quantity) of envelopes that can be loaded is as follows:
- Tray1: Approximately 27.5 mm (1.08") (20 envelopes)
- Bypass Tray: Approximately 5 mm (0.19") (5 envelopes).
• If envelopes are still not fed correctly, curl the edge of the envelopes as shown in the following illustration. The amount
of the curl should be 5 mm (0.20") or less, 2 or 3 mm (0.08 or 0.12") is recommended. The area of the curl should be 8 to
10 mm (0.32 to 0.39") from the top edge of the envelopes. Do not curl the envelopes too much or make a crease.
• To confirm the correct orientation of envelopes, see the instruction on the Envelope/Paper Setup Wizard in the print
driver.
You can print on envelopes as follows.
2 or 3 mm
(0.08 or 0.12")
8 – 10 mm
(0.32 – 0.39")
To Next Page
Loading...
Need help?
General
