User Guide
74
4.
Make sure that both width guides rest lightly against the edge of the print media stack.
• Overtightening the guides may cause jams.
Loading Labels in the Bypass Tray
• Do not load labels in the bypass tray together with other types of paper.
• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam.
• Set the paper type to [Labels] from the print driver.
• Portrait orientation is preferred, especially when printing bar codes.
• Do not print within 1 mm (0.04") of the die-cut.
• Do not print within 1 mm (0.04") of the edge of the label, of the perforations, or between die-cuts of the label.
• Do not print a label through the printer more than once.
To Next Page
Loading...
Need help?
General
