3 Using Your Printer
49
▌
[Administrator Menu] > [Network Setup] > [Wi-Fi] > [Wi-Fi Setup] > [Select access] > [Manual Setup] > [Enter
(SSID)] >
[Ad-hoc]
Configures the wireless settings in an Ad-hoc network.
▌
[Administrator Menu] > [Network Setup] > [Wi-Fi] >
[WPS Setup]
Configures the wireless network using WPS.
▌
[Administrator Menu] > [Network Setup] > [Wi-Fi] >
[Reset Wi-Fi]
Initializes wireless network settings. After executing this setting and restarting the printer, all wireless network
settings are reset to their default values.
▌
[Administrator Menu] > [Network Setup] >
[Wi-Fi Direct]
• This setting is available only when the Ethernet cable is disconnected and the wireless LAN adapter is connected to the
printer.
Configures the Wi-Fi Direct network settings.
[Mixed mode PSK]
Selects to configure the wireless setting with the encryption type
of [Mixed mode PSK]. [Mixed mode PSK] automatically selects
the encryption type from either WPA-PSK-AES or WPA2-PSK-AES.
[Passphrase Entry]
Specifies the passphrase of alphanumeric characters from 8 to
63 bytes long, and the hexadecimal characters of 64 bytes long.
[WPA2-PSK-AES]
Selects to configure the wireless setting with the encryption type
of [WPA2-PSK-AES].
[Passphrase Entry]
Specifies the passphrase of alphanumeric characters from 8 to
63 bytes long, and the hexadecimal characters of 64 bytes long.
(hex: 0-9, a-f, A-F, 16 to 64 characters)
[WEP]
Specifies the WEP key to use through the wireless network. For
64bit keys, up to 10 hexadecimal characters can be entered. For
128bit keys, up to 26 hexadecimal characters can be entered.
[WEP Key]
Specifies the transmit key.
[No Security]
Configures the wireless setting without specifying an encryption
type.
[WEP]
Specifies the WEP key to use through the wireless network. For
64bit keys, up to 10 hexadecimal characters can be entered. For
128bit keys, up to 26 hexadecimal characters can be entered.
[WEP Key]
Specifies the transmit key.
[Push Button]
Configures the wireless setting with Wi-Fi Protected Setup-Push Button
Configuration (WPS-PBC) .
[PIN Code]
Configures the wireless setting using the PIN code assigned by the printer.
You can also print the PIN code. Check it when entering the PIN assigned to
the printer into your computer.
[Wi-Fi Direct]
Enables or disables the Wi-Fi Direct network.