SELECTING THE FUNCTION
The function of the external input terminals is disabled at the factory.
Select the function to be used (following table) by installer setting of application.
* Turn on the power and select by installer setting after starting the application.
Emergency stop
Edge / Pulse
All on / All off
Electricity meter Pulse
INPUT SIGNAL TYPE
The input signal type can be selected.
Edge
L
H
Emergency stop or
All on
CH1
L
H
Emergency stop reset or
All off
Pulse
L
H
300ms or more
Emergency stop or
All on
CH1
Emergency stop reset or
All off
CH2
L
H
50ms or more
Electricity meter signal CH1
H: Energized state L: Shutoff state
When Edge was selected, only CH1 can be used. CH2 cannot be used.
- (08 - 50) -
EXTERNAL INPUT
& OUTPUT
EXTERNAL INPUT
& OUTPUT
To Next Page
Loading...
