¢
Installation procedure
Before installation, connect between the VRF network system and the USB adapter.
For details of installation, refer to the instruction manual.
Brief installation steps are follows:
1. Install an appropriate driver for the USB adapter to the PC.
In this step, do not connect the USB adapter to the PC.
2. Install the BACnet gateway (application software) to the PC.
3. Restart the PC.
4. After restarting the PC, make sure that the USB adapter, WHITE-USB-KEY, and Ethernet cable
for the BACnet gateway are connected to the PC.
5. Start the application.
6. Configure necessary settings for startup operation as follows:
a. Perform all necessary initial settings such as IP address, etc. Then, click OK button.
Adapter setting window appears automatically.
b. Select the connected adapter and click OK button. Then unit registration window appears
and starts scanning all connected units automatically.
c. After finishing the scanning, click OK button.
Gateway execution window appears on the display when the startup operation is complet-
ed.
7. Arrange the information between BMS and BACnet gateway using the read property service,
etc.
3-7. BACnet gateway (Software: UTY-ABGXZ1) - (05-154) - 3. Adaptor/Convertor units
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
