¢ Remote controller setting
(Only for Wired remote controller and Simple remote controller.)
Dual remote controller setting
Set the SW2 of DIP switch 1.
For details, refer to "Function settings" on page 07-
59.
1-2. Address setting
Address for each unit should be preset before starting system operation. Refer to "System design
" in
Chapter 6. SYSTEM DESIGN on page 06-1 to confirm the details of each unit, and perform the set-
ting.
¢ Outdoor unit addresses and setting ranges
Setting
Setting
range
Type of switch Remarks
A
Refrigerant circuit
address
00—99
Setting example
01
Arbitrary numbers can be set in
range of 00—99.
Terminal resistor ON/OFF
DIP switch SET5-4
Refer to "Terminal resistor
setting" on page 07-
56.
1-1. System type setting - (07-3) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
