Fujitsu AIRSTAGE J-IIIL - Page 506

¢ Example
• Controlling the individual operation status with two external contact switch
Setting Wiring Operation example
Mode 0
P1: Arbitrary operation state
Contact Off → On
P2: Arbitrary operation state
Contact Off → On
Other settings are arbitrary.
Indoor unit
External
SW controller
External
c
ontact SW 1
External
contact SW 2
SW1 On
Off
SW2 On
Off
Operation state On
Off
P1
P1: On, Cool, 80 °F (26 °C) P2: Off
P2
C
ool
80 °F (26°C)
• Controlling operation by On or Off of an external contact switch
Setting Wiring Operation example
Mode 1
P1: Arbitrary operation state
P2: Arbitrary operation state
Other settings are arbitrary.
Indoor unit
E
xternal
SW controller
External
contact SW 1
P1: Off P2: On, Cool, 80 °F
(26 °C)
SW1 On
Off
Operation state
P2 P1
On
Off
Cool
80 °F (26 °C)
Mode 1
P1: Arbitrary operation state
P2: Arbitrary operation state
Other settings are arbitrary.
SW1 On
Off
P1 P2
(Cool)
(Heat)
Operation state
P1: On P2Cool, 80 °F (26 °C)
Heat, 68 °F (20 °C)
88 °F (30 °C)
60 °F (16 °C)
80 °F (26 °C) 88 °F
(30 °C)
68 °F (20 °C)
60 °F
(16 °C)
Mode 1
P1: Arbitrary operation state
P2: Off timer
(1, 3, 6, 12, 24 hr)
Other settings are arbitrary.
SW1 On
O
ff
Off
P1
On Off timer
P2
Operation state
P1: On, Heat, 20 °C P2: 16 °C
Heat
68 °F
(20 °C)
Heat
60 °F
(16 °C)
3-9. External switch controller (UTY-TERX) - (05-168) - 3. Adaptor/Convertor units
CONTROL SYSTEM CONTROL SYSTEM