Fujitsu AIRSTAGE J-IIIL - Page 635

 Refrigerant circuit address setting
NOTE: Perform this setting on the master remote controller.
1.
While displaying the function setting screen, press the TEMP. “
” or TEMP. “ ” button to se-
lect the 2-wire remote controller address.
Function setting screen
Example: Selecting the 2-wire remote
c
ontroller address (002-01)
2. Press the START/STOP
/
button to switch to the function number setting.
Example: Selecting the 2-wire remote
c
ontroller address
Function number
3. Press the TEMP. “ ” or TEMP. “ ” button to adjust the function number.
Function number Function number
4. Press the START/STOP
/
button to switch to the refrigerant circuit address setting.
Refrigerant circuit address
Function number
5. Press the TEMP. “ ” or TEMP. “ ” button to adjust the refrigerant circuit address number.
Example: Selecting refrigerant
c
ircuit address data “18”
Refrigerant circuit address
1-4. Address setting by remote controller - (07-35) - 1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS