¢ Completion of function setting mode
• The position of the MANUAL AUTO button varies depending on the model. For the actual position
of the button on each unit, refer to the operation manual.
• If the MANUAL AUTO button is pressed continuously for 10 seconds or more, the error will be dis-
played. In this case, release the button or turn off the power.
1. Press and hold the MANUAL AUTO button for 3 seconds. The brightness of each LED lamp is
darkening though the content of the display does not change.
3 short beeps
MANUAL
AUTO
MANUAL AUTO
IR receiver unit
2. Press the RESET button.
For the custom code setting of b, c, or d, perform the setting after pressing the RESET button.
•
After completing the procedure above, no function setting signal is received. If the function
setting signal is sent, 5 short beeps will be emitted indicating an error.
• When returning the function setting mode again, press the MANUAL AUTO button for 3 sec-
onds.
¢ R
econfirmation of function setting
1. While holding down the
FAN and the SET TEMP.
buttons, press the RESET button. The
function setting mode will be activated.
SET TEMP. ( )
R
ESET
FAN
Function setting
mo
de display
2-4. Indoor unit (setting by wireless remote controller) - (07-81) - 2. Function settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
