Fujitsu AIRSTAGE J-IIIL - Page 711

¢ Master or slave setting of remote controller
1. Touch “RC Master/Slave Setting” on the Initial Setting screen.
Back
Previous
Page
Page 3/ 3 Initial Setting
RC Master/
Slave Setting
2. RC Master/Slave Setting screen is displayed. Select “Master” or “Slave”.
R.C. Master / Slave Setting
Cancel OK
Master
Slave
When the “OK” is touched, the display returns to the Initial Setting screen.
NOTE: Set only one master remote controller. Units other than “Master” are set to “Slave” automat-
ically. Do not perform “RC Mater/Slave Setting” during setting or operating from the master
unit.
¢ I
ndoor unit address verification
1. When “I.U. Address Verification” on the Maintenance screen is touched, Installer Password
Verification screen is displayed.
Enter the Installer Password, and touch “OK”. I.U. Address Verification screen is displayed.
Previous
Page
Back
Next
Page
Page 2/ 3 Maintenance
Test Run
R.C. Address
Setting
Function Setting
I.U. Address
Setting
1 002–1 01–01
/
002–2 01–02
/
2
002–3 01–03
/
3
002–4 01–04
/
4
002–5 01–05
/
5
002–6 01–06
/
6
/
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
Back
Check
Next
Page
2. When the screen has multiple pages, they can be switched by touching the “Next Page” or
“Previous Page”.
1 002–1 01–01
/
002–2 01–02
/
2
002–3 01–03
/
3
002–4 01–04
/
4
002–5 01–05
/
5
002–6 01–06
/
6
/
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
Back
Check
Next
Page
3. Touch the “Check” on the I.U. Address Verification screen.
1 002–1 01–01
/
002–2 01–02
/
2
002–3 01–03
/
3
002–4 01–04
/
4
002–5 01–05
/
5
002–6 01–06
/
6
/
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
Back
Check
Next
Page
2-15. Wired remote controller (Touch panel) - (07-111) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS