Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

5.3.14 Resuming BitLocker functionality 86
5.3.15 Performing a RAID array rebuild 87
5.3.16 Looking for MAC/WWN/GUID and SAS addresses 88
5.3.16.1 Basic information 88
5.3.16.2 Looking for the MAC address of a LAN controller 89
5.3.16.3 Looking for the WWN address of a fibre channel controller 90
5.3.16.4 Looking for the GUID address of an infiniband or Omni-Path
controller 90
5.3.16.5 Looking for SAS addresses of SAS controllers for external
devices 91
5.3.17 Using the Chassis ID Prom Tool 91
5.3.18 Configuring LAN teaming 93
5.3.19 Switching off the ID indicator 95
5.3.20 Performing a fan test 96
6 Power supply unit (PSU)
99
6.1 Safety notes 99
6.2 Basic information 99
6.3 Standard power supply 100
6.3.1 Replacing the standard PSU 100
6.4 Redundant power supply 105
6.4.1 PSU bays 105
6.4.2 Installing a hot-plug PSU 105
6.4.3 Removing a hot-plug PSU 108
6.4.4 Replacing a hot-plug PSU 112
6.4.5 Replacing the power distribution board 114
6.5 Fujitsu battery unit (FJBU) 124
6.5.1 Installing an FJBU 124
6.5.2 Removing an FJBU 125
6.5.3 Replacing an FJBU 126
6.6 Converting a standard power supply to a redundant power
supply 127
Content
Upgrade and Maintenance Manual RX1330 M4

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller