Preliminary steps
▶
"Shutting down the server" on page 45
.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 48.
▶
Remove the riser module 2 and the riser module 3, see "Removing a riser
module" on page 59.
Installing the upgrade kit
Figure 129: Removing the riser module support
▶
Remove the screw (1).
▶
Remove the riser module support (2).
▶
Remove the riser card from riser module 3, see "Removing the riser card"
on page 208.
Expansion cards and backup units
RX1330 M4 Upgrade and Maintenance Manual 215
To Next Page
Loading...
